Check whether Helifreak.com server is down right now or having outage ... If no bar is displayed for a specific time it means that the service was down and the ...
No known problems with ServoKing servos (oem for BK). ... Trying to see if we can "slow down" brain update rates (not refresh) to see if it helps with these servos ...
Both skids touch down, blades are spooling down, then it tips over. There was a bit of a cross wind, not severe. Landings on other helis with BeastX are always ...
No, they are not good settings for learning 3D. Ultimately, it's just to allow you to buzz around a little easier and get comfortable with the chopper. Only my $0.02.
When I give throttle, it will lift off a few inches, then fall down again.. it will sort of hop, but not take off. I am pretty sure it is not the battery; I have three of them, and ...
5 May 2017 ... Download the video and watch it on VLC ore other compatible video ... from my laptop which is down on the table downstairs they will not play.
Inspect your swashplate guide pin and ensure it isn't pushed all the way down in the swash guide. No? Check out the 'Other Symptoms' at the bottom. Read ...
A. Do not fly to LVC, and make sure the heli is free of hair and dust and is lubed ... Only thing I can think to check is that the throttle trim is all the way down.
16 Apr 2016 ... There's a new firmware for the HW 60A platinum pro V4, but no ... It stays off unless I move my collective up and down then it blinks on for a ...
The iKon heli moved the rotor disk down in front and about 15° left instead of ... started one or 2 on this subject over the last 18 months and I'm still not flying.
General troubleshooting tips for a wagging tail, these apply to all gyros not ... ill spin the heli up with no main or tail blades and hold the frame down and spin it ...
The canopy can't go down any farther without rubbing on the top of the motor. ... Note: The German store/distributor (freakware.de) where I bought it online isn't ... The hole is not so much off so drilling another hole right next to it will probably ...
